Designing Cisco Network Service Architectures 300-320 ARCH exam sample questions Passtcert

I believe that a lot of people working in the IT industry hope to pass some IT certification exams to obtain the corresponding certifications. Some IT authentication certificates can help you promote to a higher job position in this fiercely competitive IT industry. Now the very popular Cisco 300-320 authentication certificate is one of them. Although passing the Cisco certification 300-320 exam is not so easy, there are still many ways to help you successfully pass the exam. While you can choose to spend a lot of time and energy to review the related IT knowledge, and also you can choose effective Designing Cisco Network Service Architectures 300-320 ARCH exam sample questions.

Share some CCDP 300-320 exam questions and answers below.
Which protocol should be run on the LAN side of two edge routers (that are terminating primary and backup WAN circuits) to provide quick failover in case of primary WAN circuit failure? 
A. VTP 
B. STP 
C. VRRP 
D. RIP 
Answer: C

What is the maximum number of neighbors that a router should have in an OSPF area? 
A. 5 
B. 30 
C. 60 
D. 99 
Answer: C

What is the recommended subnet between two sites that have a point-to-point connection to conserve IP addresses? 
A. 255.255.255.0 
B. 255.255.252.0 
C. 255.255.255.252 
D. 255.255.255.240 
Answer: C

Which unique EIGRP feature allows for faster Layer 3 convergence? 
A. fast EIGRP timers 
B. feasible successors 
C. hybrid routing protocol 
D. Cisco proprietary protocol 
Answer: B

An HSRP design requirement states that preemption must be enabled for the active switch, which is a Cisco 4507R. Assume a boot time of 300 seconds. 
Which setting of the preemption delay timer minimizes the loss of traffic? 
A. 50 seconds 
B. 100 seconds 
C. 150 seconds 
D. 200 seconds 
Answer: D 


Which multicast implementation strategy provides load sharing and redundancy by configuring intradomain RPs as MSDP peers? 
A. anycast RP 
B. auto-RP 
C. bootstrap router 
D. static RP 
Answer: A 


What is the correct state between two BGP peers that are neighbors? 
A. active 
B. operational 
C. established 
D. up 
Answer: C

Passtcert pledge to customers is that we can help customers 100% pass their IT certification exams. The quality of Passtcert Designing Cisco Network Service Architectures 300-320 ARCH exam sample questions has been recognized by many IT experts. The most important characteristic of our products is their pertinence. It only takes 20 hours for you to complete the training course and then easily pass your first time to attend Cisco certification 300-320 exam. You will not regret to choose Passtcert, because choosing it represents the success.

Passtcert guarantee exam success rate of 100% ratio, except no one. You choose Passtcert, and select the Designing Cisco Network Service Architectures 300-320 ARCH exam sample questions you want to start, you will get the best resources with market and reliability assurance.Cisco certification 300-320 exam is one of the many IT employees' most wanting to participate in the certification exams. Passing the exam needs rich knowledge and experience. While accumulating these abundant knowledge and experience needs a lot of time.

Related article: http://70-413-update.blogspot.com/2017/09/cisco-300-320-arch-exam-dumps-passtcert.html